11
KX2500.1 Amplifier
Installa
tion
USING THE SIGNAL OUTPUT JACKS (PAST)
The Output (Pre Amp Signal Transfer) RCA jacks allow you to
send the incoming signal from one Kicker KX2500.1 series
amplifier to another amplifier or processor without the need for Y
cables. The signal from the PAST jacks is identical to the signal
fed to the amplifier via its RCA input jacks or the High Level
inputs and is not affected by the amplifier’s built in crossover.
Most head units with high voltage outputs should be capable of
driving up to ten amplifiers in a chain.
REMOTE BASS LEVEL CONTROL
When using the Remote Bass Level Control you have the
ability to control the level of the subs from the driver’s seat. To
mount the controller simply screw the metal bracket to the
chosen location, then slide the housing onto the bracket until it
snaps into place. Run the cable from the controller to the
remote (REMOTE BASS) jack on the amplifier chassis.
When using more than one KX2500.1 amplifiers you have the
ability to control all of them from one Remote Bass Level Control.
The adapter is a common Modular Phone Splitter found at Radio
Shack and is installed between the controller and the amplifiers.
Use additional RJ11 cords (4 conductor phone cords) to connect
the amplifiers to the Modular Phone Splitter.
SOURCE UNIT
Left +
Left -
Right -
Right +
Speaker
Outputs
RCA
Outputs
WARNING!!!
Use Only The Speaker Outputs
OR
the RCA Outputs.
Never Both At The Same Time !!!
To Next Amplifier
REMOTE BASS
LEVEL CONTROL
To Other
Amplifiers
Common Modular
Phone Splitter
Mounting Surface
REMOTE
BASS
REMOTE
BASS
