We’re here to help
866-558-5706
Hrs: M-F 9am to 5pm EST
IS-TE-Series PRO Channels Rod Installation-US
TE-Series PRO Channels
Rod Installation Instructions
MODEL:
1TEC1RDSF8SIL
MODEL:
1TEC1RDSF8SIL
INSTALLATION:
1) Prep electrical feed as
necessary.
2) In a straight line, mount
the mounting clips using
appropriate hardware for your
application.
3) Assemble Tape light as typically
instructed. Install the tape light
in the channel.
4) Snap in lens.
5) Fasten end caps with provided
screws. Note: Consider
electrical connections before
closing the endcaps. Wire can
exit through endcap or wrap
around inside the endcap to
exit at the rear of the channel.
6) Snap the channel into the
mouting clips.
7) Rod channel may be oriented at
various angles. The mounting
clip will snap into the groove
features on the channel
securing the channel.
INSTALLATION:
1) Prep electrical feed as necessary.
2)
In a straight line, mount the mounting clips using appropriate hardware
for your application.
3) Assemble Tape light as typically instructed. Install the tape light on
the beam adjusting insert. Because this assembly has moving parts,
soldered connections are required.
4)
Thread the cam screws (Threaded rod hex bolts) into the beam adjusting
insert ends (One per side).
5)
Align the beam adjusting rings (End cap) with the cam screws. The cam
screw will reside in the small opening in the adjusting ring.
6) Snap in lens.
7) Fasten end caps with provided screws. The end cap has a pivot point the
adjust ring must mate with to ensure proper function of the beam adjust
insert. Note: Consider electrical connections before closing the endcaps.
Wire can exit through endcap or wrap around inside the endcap to exit
at the rear of the channel. Leave plenty of slack for moving parts.
8)
Snap the channel into the mounting clips. Note: Rod channel may be
oriented at various angles. The mounting clip will snap into the groove
features on the channel securing the channel.
With beam adjusting insert:
