4a. If mounting fixture on a stud, drill holes for
mounting hardware where marked in Step
1a. Using a 1/16" drill bit (not included), drill
a 1/16" pilot hole at each marked location
for the stud mounting screws (GG).
Hold mounting bracket (B) flat against wall
(with mounting hardware slots positioned
over 1/16” pilot holes) and screw stud
mounting screws (GG) into pilot holes.
Tighten stud mounting screws (GG) to
secure mounting bracket (B) to wall.
6
4a
B
GG
7
ASSEMBLY INSTRUCTIONS (PLUG-IN MOUNTING)
5a. Pass canopy (A) over the screws
protruding from the mounting bracket (B)
and secure in place with lock washers (DD)
and threaded knobs (CC).
NOTE: Make sure all wires are inside of
canopy (A) and do not get pinched
between canopy (A) and mounting bracket
(B), or canopy (A) and wall.
NOTE: Fixture should be mounted with
socket (C) in the down position as shown.
Go to Step 1c on Pg. 12
5a
8
Hardware Used
x 2
Stud Mounting Screw
GG
Hardware Used
x 2
Lock Washer
DD
x 2
Threaded Knobs
CC
DD
CC
B
A
C
