60" PINION
13
Blade Arm
Screw
Screw
Lower Housing
Washer
Blade
Screw
INSTALLING THE LOWER HOUSING
NOTE:
Before continuing , make sure the power is disconnected by turning
off the circuit breaker of removing the fuse at the circuit box.
Step 1.
Remove three (3) screws as shown and save for later use. (Fig. 21)
Step 2.
Attach the lower housing to motor body, insert three (3) screws
previously removed into the holes and securely tighten them. (Fig. 22)
ATTACHING THE FAN BLADES
NOTE:
Before continuing , make sure the power is disconnected by turning
off the circuit breaker of removing the fuse at the circuit box.
Step 1.
Position the blade over the blade arm with threaded posts showing.
Make sure the bottom edge of the blade is fully seated against the blade arm.
With a Phillips screwdriver, start a blade screw and washer into the blade
arm (do not tighten) and repeat for the 2 remaining blade screws and
washers. Tighten each screw securely starting with the center screw. Make
sure the blade is straight. Repeat steps for the remaining blades. (Fig. 20)
Fig. 20
Fig. 21
Fig. 22
