Unite
®
Panel System - Worksurface with Pedestal Support Installation
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
21
#14 x /
7
8
”
screw
#12 x /
3
4
”
screw
return peninsula
worksurface
(24 width shown)
”
Typical Return Peninsula with
Pedestal Support Installation
Note:
Peninsula worksurfaces
are to be less than 72” in length,
and are available in 22”, 24” and
30” widths, plus 24KN & 30KN
widths.
1. Place a peninsula attachment
plate under the adjacent
worksurface. Center the plate
from side-to-side and position
the overhang of the plate allowing
2
1
/
2
” for attachment of the
peninsula worksurface
(Figure 27). Using a pen and the
properly positioned attachment
plate as a template, mark the
center of all attachment hole
locations to the underside of
the adjacent surface. Remove
the plate, and using a drill with
1
/
8
” diameter drill bit, carefully
pre-drill mounting holes to only
1
/
2
” depth in underside of adjacent
worksurface. Take care to not drill
too deep (Figure 27).
Note:
22” and 24” deep peninsula
surfaces will use a 21” long
peninsula attachment plate and
30” deep surfaces use a 25” long
attachment plate. The 21” & 25”
mounting plates have a different
number of holes. Use all mounting
holes to secure.
2. Replace the attachment plate over
the pre-drilled holes and secure
plate to underside of adjacent
worksurface using #12 x
3
/
4
”
screws. Take care to not
over-tighten screws (Figure 27).
3. Place pedestal to the approximate
location it will install under
the peninsula worksurface.
Set peninsula worksurface
onto pedestal and peninsula
attachment plate. Adjust glides on
pedestal to level the worksurface
and center the worksurface on
attachment plate making sure
worksurface edges are tight. Take
care to not drop or damage the
worksurface. Using the attachment
plate as a template, pre-drill
1
/
8
” diameter mounting holes to
only
1
/
2
” depth in underside of
peninsula surface. Take care to
not drill too deep (Figure 27).
4. Secure splice plate to peninsula
worksurface using #12 x
3
/
4
”
screws. Take care not to
over-tighten screws (Figure 27).
Note:
If installing a double
pedestal (not shown), no holes
are pre-drilled into the underside
of the peninsula worksurface for
installation. Once the double pedestal
is aligned square, use the pedestal
mounting holes as a template, and
pre-drill using
1
/
8
” drill bit to depth of
1
/
2
”
into underside of worksurface. Take care
to not drill too deep.
5. To attach pedestal to underside of
worksurface, first align pre-drilled holes
of worksurface with mounting holes of
pedestal. Check that the front and side of
the pedestal is flush with the edges of the
worksuface and secure using four
#14 x
7
/
8
” screws as illustrated
(Figure 27).
Note:
If a Knife Edge worksurface is
being installed, the pedestal will be set
back from the front edge of worksurface.
6. Re-install pedestal drawers by
following steps 7 & 8, page 20 (previous
page).
