Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Assembly Instructions
Ruckus™
Worktable
April 2017
1. Carefully unpackage the worksurface
and place it face down on a soft
protective surface. Locate six hanger
bolts from the hardware pack and
screw them into the underside of
the worksurface at pre-drilled hole
locations as illustrated. Tighten the
bolts snug, but not too tight. Correct
gap space under the head is required
to accept the key-hole slots of end
and center panels (Figure 1 &
Detail A).
2. One at a time, orient each end panel
as illustrated over the hanger bolts
on the worksurface. Position the
panel with “hook holes” facing
outward and close to the worksuface.
Set the panel onto the hanger bolts
such that the bolt heads go through
the larger opening in the key-hole
slots, then slide the panel with force
so the slot completely captures the
hanger bolt head. If sliding the panel
is too difficult, the hanger bolt(s)
may need to be loosened slightly
(Figure 1).
3. Next, position the center panel onto
the hanger bolts between the two end
panels and install the center panel in
the same manner as for end panels in
step 2 above (Figure 1).
Figure 1
hanger
bolt
end panel
end panel
center
panel
hanger
bolt
table
top
“hook holes”
hanger
bolt
hanger
bolt
key
slot
table top
end
panel
Detail A
