Enlite Tables
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
3
ADA WHEELCHAIR HEIGHT
TABLES
Important
: Not all of the required
base attachment pilot holes are
pre-drilled in the table top. It is
important that pilot holes be drilled
for the remaining mounting screws
to avoid damage to the table top
(Detail C). ADA table bases must be
secured with ten screws each.
1. Carefully place table top upside
down on a soft protective
surface.
2. Line up the attachment holes
at the outer corners of the
bases with the pre-drilled holes
(Figure 5).
Note:
Depending on the table,
there will be six or seven pilot
holes aligned with the base
attachment holes.
3. Secure bases to the table
top using #12 x
3
/
4
”
Phillips pan head screws
(Figures 5 & 6).
4. Drill
1
/
8
"
diameter pilot holes
5
/
8
"
deep into three or four
available attachment points to
complete ADA leg attachment
(Detail C).
5. Install #12 x
3
/
4
” Phillips
pan head screws into holes
drilled in step 4.
Note:
There should be five
screws on each side of leg.
For Post leg (Boomerang
& Scale-up tables)
, secure
leg to table top using ten
#12 x
3
/
4
” Phillips pan head
screws per leg (Figure 6).
6. Screw casters or optional
glides into threaded leg tubes.
(Figures 5 & 6).
Note:
Locking casters should
be installed on user’s side of
table (Figure 5 & Detail B).
For Post legs, use non-locking
casters only (Figure 6).
7. Tighten casters using
3
/
4
”
open
wrench. Turn optional gliders
until about
1
/
2
”
of telescoping
shroud material remains
visible.
Summary of Contents for Enlite ENBT AD Series
Page 1: ...Assembly Instructions Enlite Tables March 2017...
Page 2: ......
