2.7.4
Ethernet network diagnosis
The Ethernet network diagnosis, shows the result in the form of a sum of the failed
operations. It also displays the HTTP protocol status returned from attempting to send a connection
status over the Ethernet network to the server.
Test
Failure value
Ping default gateway
1
Ping DNS 1
2
Ping DNS 2
4
Ping proxy IP (if any)
8
Ping IP from server
16
HTTP POST == 200 (use proxy if one exists)
32
2.7.5
Mobile network (3G) diagnosis
The modem diagnosis performs a series of AT commands and shows its results. The AT
commands covered by the modem diagnosis are:
●
Modem signal quality (AT+CSQ).
●
Network registration status (AT+CREG).
●
Network you are registered with (AT+COPS).
●
Registration status (AT+CGREG).
●
SIM card ICCID (AT+CCID).
2.7.6
Enable DHCP
This option allows the user to enable automatic obtaining of the network IP. To select it is
necessary to click on the right button once and then go to the Yes option and again click on the right
button.
3. Installation
3.1
Ethernet network connection
The ITG 200 has two fast Ethernet network interfaces (10/100 Mbps) for connection to
different networks. The two interfaces have the same IP address and therefore must not be
connected to the same data network.
It is possible to access the Web Interface through either of the two network ports when the
gateway is in its factory settings.
Attention
Each network interface must be connected to a separate data network.
7
Summary of Contents for ITG 200Indoor
Page 1: ...User Manual ITG 200 Indoor...
