Instruction Manual
20
KGS Corporation
2. How to make braille tape
This chapter mentions procedures to print braille dots on tape after connect
BL-1000 to PC.
If the necessary software’s haven’t been installed into PC, please refer to the
chapter of [1.8 Preparation for PC before connect BL-1000 with it] and start to
install.
2.1 Connecting BL-1000 with PC
Connect BL-1000 with PC, according to the following instructions.
Procedures
1.
Connect AC Adaptor to BL-1000.
Then the head of braille tape is automatically at the starting point to print dots.
Set new braille tape, if it is exhausted.
2.
Boot PC.
3.
Connect BL-1000 with PC by a USB cable.
2.2 Making the braille dots tape by use of Braille Labeler Utility
2.2.1 Boot and Exit
It is possible to boot Braille Labeler Utility by one of the following procedures.
1.
Double Click on the Icon of Braille Labeler Utility on desktop.
2.
Start Menu, to “Program”, and Double clicked on “Braille Labeler Utility” in
the file of “Braille Labeler”.
Double click the Text File (extension .kbld), in the case of to use recorded text.
