Step 3: Mark holes for installation
An installation template has been provided to help position your pilot
holes. To use the template, temporarily attach your template to your
mounting surface (Fig. D ) and drill your pilot holes in the four shaded
areas as shown in Fig. E. Remove the template before moving to the next
step.
Fig. D
Fig. E
Step 4: Install Brackets
Using the provided screws, install the Crank Bracket and Plug Bracket
(Fig F and G). Note: The Crank Bracket should be placed on the right
side of the shade and the Plug Bracket should be placed on the left side
of the shade.
Step 5: Install Shade
To install your shade, start by inserting the Crank Plug into
the Crank Bracket (Fig H).
Next rotate/open the Plug Bracket and insert the shade, mak-
ing sure to hear a “click” as the pin locks into place (Fig I).
If your shade moves side-to side after installation, we rec-
ommend that you adjust the brackets to reduce any lateral
movement between the shade and the brackets.
To reduce lateral movement, roll your shade down and loosen
the screws on both of your brackets slightly. Push the brack-
ets in, (towards each other), to reduce the distance between
the brackets (Fig J).
Fig. F
Fig. G
Fig. H
Fig. I
Open Bracket
Push brackets in to
reduce slack
Fig. J
STEP 6: Assemble Pole
To assemble your pole, slide the Pole-Mid Piece onto the
Pole-Long Piece, making sure the holes are pointing towards
the handle (Fig L). Then, slide the Pole-Handle Piece into the
Pole-Mid Piece .
Insert the Pole Screws into the Pole-Mid Piece and completely
tighten (these screws are located in your pole package). Note:
Not all of the Pole-Long Piece is shown in (Fig L).
To use the pole simply insert the hook into the Ring and turn
the Pole-Handle Piece.
Fig L
Pg. 2
