Install the Modules
4
Keysight M9241/42/43A PXIe Oscilloscopes and M9240A AutoProbe Power Module Startup Guide
19
a
Install the module into the slot of the chassis by placing the module card
edges into the front module guides (top and bottom).
b
Slide the module to the rear of the chassis and ensure that the
injector/ejector handle is pushed down in the unlatched (downward)
position.
c
Slide the module completely into the chassis. When you begin to feel
resistance, pull up on the injector/ejector handle to fully inject the module
into the chassis.
7
Secure all modules to the chassis using the module mounting screws. Use a #1
Pozidriv® or a slotted screwdriver and torque to 5 Lb-In (0.57 N-m).
Performance may suffer if the screws are not tightened properly.
8
Verify that the PXI chassis fans are operable and free of dust and other
contaminants that may restrict airflow.
9
Install filler panels and slot blockers after installing the modules. Missing filler
panels or slot blockers may disrupt air circulation in the chassis. The left-most
slot does not accept a slot blocker.
10
If you are using a PCIe Cable Interface, such as the Keysight M9021, connect
the Cable Interface in the chassis to the PC host per the instructions that came
with the Cable Interface.
11
Power up the PXI chassis.
12
If you are using a remote PC controller, reboot the PC host controller.
13
Proceed to
, “Verify Operation,” starting on page 29.
Front Panel Features
This section describes the front panel features, that is, connectors and LEDs, for
the M9241/42/43A PXIe oscilloscope and the M9240A AutoProbe power module.
