User Guide
3
Keysight E6953A V2X Test Solution Installation & User Guide
39
Figure 3-10
TCI V2X DUT settings panel
–
Radio
- The radio used by the DUT for physical layer transmission. Default
value is “Radio_radio0”.
–
Antenna
- The antenna that the radio uses for transmission. Some DUT uses
antenna2 and some uses both. Normally the RF cable is plugged into the
antenna1 and if that’s the case, this field should be set to “Antenna_antenna1”.
Default value is “Antenna_antenna1”.
– FrameType
-
Frame type defines the type of WAVE frame the DUT is set to put
out. For 80211p, frame type is now set to “PduType_d16093frame” the same
for 1609.3 and 1609.4. Default value is “PduType_d16093frame”.
–
IP Address (Ipv4)
-
This field sets the Ipv4 address of the IUT. The test system
TCI interface uses this value to communicate with the DUT.
–
TCP Port
-
This field sets the UDP port number for TCI communication. Default
value is “13001”.
