Keysight Technologies M9403A, User'S And Service Manual

Page: 14 / 27

11
M9403A and M9404A Install the Software
Install the M9403A and M9404A
NOTE The M9403/04A can be used in a chassis with a PXIh chassis peripheral slot.
The M9403/04A can also be installed in any hybrid PXI slot marked with a peripheral
slot compatibility image (the letter "H" and a solid circle containing the slot number).
CAUTION PXI hardware does not support “hot-swap” capabilities (changing modules while
power is applied to the chassis).
Before installing a module into the chassis, the chassis must be powered off to
prevent damage to the module.
1. Ensure that the PXI chassis power switch is in the off (Standby) position.
2. If the chassis has multiple fan speed settings, ensure that the fans are set to automatic. Do
not set the fan speed to low or turn it off.
3. Position the chassis so that there is ample space between the chassis fan intake and exhaust
vents. Blockage by walls or obstructions affects the air flow needed for cooling. (Refer to the
chassis documentation for more information about cooling).
4. Holding the module by the injector/ejector handle, slide it into the card edges on the guide
slot (top and bottom) as shown in Figure 5 .
a. Slide the module to the rear of the chassis and ensure that the injector/ejector handle is
pushed down in the unlatched (downward) position.
b. Slide the module completely into the chassis. When you begin to feel resistance, push up
on the injector/ejector handle to fully insert the module into the chassis.
Figure 5
Installing the Module