Keysight M9035A PXIe Embedded Controller Startup Guide
27
Controller Operating System
Controller Operating System
Your M9035A comes with the Microsoft Windows operating system pre-installed
along with the latest version of Keysight's IO Libraries Suite. This section provides
some general system configuration and preventative maintenance procedures
that you, the customer, are responsible for. In general, the M9035A operates as
any other PC, including remote desktop access.
The Windows operating system supplied with your M9035A is licensed for use on
the hard drive mounted to the controller. If the hard drive is replaced, it may be
your responsibility to purchase or relicense the operating system.
M9018 PXIe Chassis PCIe Link Configuration
This discussion is applicable when using the M9035A in an M9018A or M9018B
PXIe Chassis. It does not apply for use with the M9019A or M9010A PXIe chassis,
because they have a fixed configuration of 1x8 and 1x16 for their PCIe Link fabric.
PCIe link configuration
refers to how the PXIe chassis PCIe Switch Fabric is
configured to connect PCI Express signals between slot 1, the system controller
slot, and the other chassis slots. For a review of the supported PCIe link
configurations, please refer to the
PXIe Chassis User Guide
(available from the
Windows
Start
button, then look under Keysight).
For a detailed graphics, explaining the operation of the chassis PCIe data paths,
see the
Keysight PXIe Chassis Interactive Block Diagram
at
www.keysight.com/find/pxi-blockdiagram
Keysight’s M9035A embedded controller can boot and run with all of the PCIe
switch fabric configurations supported by the M9018 chassis. The supported
switch fabric configurations are:
- 1x8 Configuration
— Referred to as 1x8, this configuration provides one x8 link
from the M9035A embedded controller to the PCIe switch fabric. While the
1x8 configuration will work with the M9035A, it is better suited for use with
the M9021A system module which supports 8 PCIe lanes.
- 2x8 Configuration -
Referred to as 2x8, this configuration provides two x8 links
from the M9035A embedded controller to the PCIe switch fabric. The two x8
links provide the highest performance I/O to the 18 chassis slots; therefore,
the 2x8 configuration is recommended for use with the M9035A.
The default Administrator password is
Keysight4u!
Keysight recommends that you change the password.
