Keysight Technologies InfiniiVision 3000T X Series, Programmer'S Manual

Page: 474 / 1420

474 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
22
:MEASure Commands
:MEASure:DUAL:VAVerage
(see page 1276 )
Overview This measurement is available with the N2820A high sensitivity current probe
when both the Primary and Secondary probe cables are used. This measurement
joins the Zoom In waveform data below the probe's clamp level with Zoom Out
waveform data above the probe's clamp level to create the waveform on which the
measurement is made.
Command Syntax
:MEASure:DUAL:VAVerage [<interval>][,<source1>][,<source2>]
<interval> ::= {CYCLe | DISPlay}
<source1>,<source2> ::= CHANnel<n> with N2820A probe connected
<n> ::= 1 to (# analog channels) in NR1 format
The :MEASure:DUAL:VAVerage command installs a screen measurement and
starts an average value measurement.
The <interval> option lets you specify the measurement interval: either an integral
number of cycles, or the full screen. If <interval> is not specified, DISPlay is
implied.
If the optional source parameter(s) are specified, the currently specified source(s)
are modified.
Query Syntax
:MEASure:DUAL:VAVerage? [<interval>][,<source1>][,<source2>]
The :MEASure:DUAL:VAVerage? query returns the average value measurement.
Return Format
<value><NL>
<value> ::= calculated average value in NR3 format
See Also • ":MEASure:DUAL:CHARge" on page 472
• ":MEASure:DUAL:VAMPlitude" on page 473
• ":MEASure:DUAL:VBASe" on page 475
• ":MEASure:DUAL:VPP" on page 476
• ":MEASure:DUAL:VRMS" on page 477
• "Introduction to :MEASure Commands" on page 458
• ":MEASure:SOURce" on page 499