17
workout. Press ENTER.
6. The INCLINE/PULSE window will flash ‘125’, which is the default program target heart rate.
Use PROGRAM UP and PROGRAM DOWN buttons to select Target Heart Rate. The minimum is
60 and Maximum is 225 BPM. Press ENTER.
7. Press START/STOP button. Belt will begin to move after 4 seconds. Step on belt slowly after
the belt starts moving.
8. The incline window (if receiving your heart rate accurately) will show current BPM. (If the
receiver is not receiving an accurate reading, the incline window will be flashing - - - -, or
will revert to showing current Incline level).
9. The default setting for INCLINE is 3%.
10. To adjust the pre-set target heart rate press the UP or DOWN button.
DO NOT STOP TO START OVER. Continue exercising and your heart rate will naturally
increase. The program will continually monitor your heart rate and periodically adjust
the incline up or down to increase or decrease the resistance thereby keeping you at
your target zone. At the conclusion of the programmed time the TIME window will flash
selected time and the CALORIES/DISTANCE window will continue to accumulate values.
The treadmill will continue operation until the START/STOP button or the PAUSE button is
pressed. Press the POWER button to turn off the treadmill.
NOTE: If signal is interrupted, the unit will hold the last recorded BPM for 5 seconds. After
those 5 seconds, --- will displayed in the INCLINE window for an additional 5 seconds. After
a total of 10 seconds has elapsed with no signal, the INCLINE window will begin to show the
incline only, while still continually searching for a signal.
Use the following instructions to operate Programs P17 - P20:
1. Press the PROGRAM UP button until the selected program is chosen. Press ENTER. The Time
window will blink. Default will be set at 30 minutes. Use SPEED + or - arrows or toggles
to select your workout time. Press ENTER. Minimum Time is 5 minutes, Maximum is 60
minutes.
2. The SPEED window will then blink. Use the SPEED + or - arrows or toggles to select the
AGE. Press ENTER. The default for the AGE will be 35. The unit will remember the last Age
entered. To reset to factory standard, press pause while TIME window is flashing will flash,
indicating reprogramming is allowed.
3. The speed will default at 3 MPH and the Incline will default 3% These figures may be changed
during operation.
4. DO NOT STOP TO START OVER. Continue exercising and your heart rate will naturally
increase. The program will continually monitor your heart rate and periodically adjust the
incline up or down to increase or decrease the resistance thereby keeping you at your target
zone. At the conclusion of the programmed time the TIME window will flash selected time
and the CALORIES/DISTANCE window will continue to accumulate values. The treadmill will
continue operation until the START/STOP button or the PAUSE button is pressed. Press the
POWER button to turn off the treadmill.
Console Instructions
