Maintenance Instructions
WARNING!
Before performing any maintenance to your treadmill, always unplug the power
cord from the surge protector.
CLEANING
Routine cleaning of your HT403T Fitness treadmill will extend the life of your treadmill.
WARNING! To prevent electrical shock, be sure the power to the treadmill is OFF and the unit
unplugged from the wall electrical outlet before attempting any cleaning or maintenance.
AFTER EACH WORKOUT:
Wipe off the console and other treadmill surfaces with a clean,
water dampened soft cloth to remove excess perspiration. USE NO CHEMICALS.
WEEKLY:
Use of a treadmill mat is recommended for ease of cleaning. Dirt from your shoes
contacts the belt and eventually makes it to underneath the treadmill. Vacuum underneath
treadmill once a week.
DECK LUBRICATION
The walking belt has been pre-lubricated at the factory. However, it is recommended that the
walking board be checked periodically for lubrication to ensure optimal treadmill performance.
Every 30 days or 30 hours of operation, lift the sides of the walking belt and feel the top sur-
face of the walking board as far under as you can reach. If you feel signs of silicone, no fur-
ther lubrication is required. If it feels dry to the touch, follow the instructions below.
Keys Fitness recommends “Lube N Walk” for cleaning and lubricating the treadmill belt and
deck. Ask your retailer or call Keys Fitness at 888-340-0482. You may also use silicone such as
“Napa 8300” (available at most NAPA Auto Parts stores).
TO APPLY LUBRICANT TO THE WALKING BOARD
1) Position the walking belt so that the seam is located on top and in the center of the center
of the walking board.
2) Insert the spray nozzle into the spray head of the lubricant can.
3) While lifting the side of the walking belt, position the spray nozzle between the walking belt
and the board approximately 6” from the front of the treadmill. Apply the silicone spray to the
walking board, moving from the front of the treadmill to the rear. Repeat this on the other side
of the belt. Spray approximately 4 seconds on each side.
4) Allow the silicone to ‘set’ for one minute before using the treadmill.
WARNING: Do not over-lubricate the walking board. Excess lubricant should be wiped
off with a clean towel.
16
