KE-350 Installation and Operations Manual
Programming System Setup (continued)
Keypad Status after Step Completion
Using Duress Codes (Default: OFF)
a) Enter 4 #
b) Enter 0 # to turn OFF use of Duress Codes
-- or --
Enter 1 # to turn ON use of Duress Codes
c) Return to Step 3
☞
Important Note: Duress Code Setup must be determined and programmed prior to User Programming!!!
You should hear a triple beep after completing step b indicating the use of duress codes has been
successfully reprogrammed. A long steady beep indicates an error (i.e. There may be individual user codes
already programmed into the system . These codes must all be deleted in order to set duress option to ON.)
Configuring 2
nd
Relay (Default: Aux 5 Sec
)
a) Enter 5 #
b) Select the desired configuration:
External Alarm
I.
Enter
1
#
II. Enter the desired Shunt Output Time
(01 - 99 seconds), followed by #
Internal Alarm
I. Enter 2 #
II. Enter the desired Door Ajar Time in
two digits(01-99 seconds), followed by #
Auxiliary Device
I. Enter 3 #
II. Enter the momentary output time in two
digits (01-99 seconds), followed by #
Step
;
Beep
Red LED
Green LED
a)
Double Slow Flash Slow Flash
b)
Triple Slow
Flash Solid
Step
;
Beep
Red LED
Green LED
a)
Double Slow Flash Slow Flash
I.
Double Slow Flash Fast Flash
II.
Triple Slow
Flash Solid
I.
Double Slow Flash Fast Flash
II.
Triple Slow
Flash Solid
I.
Double Slow Flash Fast Flash
II.
Triple Slow
Flash Solid
-- or --
Enter 0 0 to set the auxiliary device for Manual Operation (ON/OFF), followed by #
c) Return to Step 3
Examples: 5 # 1 # 1 5 #
Ö
Set External Shunt Alarm Option for 15 seconds
5 # 2 # 1 0 #
Ö
Set Internal Alarm with a 10 second Door Ajar Time
5 # 3 # 0 0 #
Ö
Set Auxiliary Device with Manual Operation
14
