KE-350 Installation and Operations Manual
System Programming Overview
Once the KE-350 has been installed, the system is ready for programming. Before
proceeding with actual programming, we recommend you review the Suggested Initial
Programming Steps, System Defaults, System Options and the System Programming
Commands & Feedback. In addition, we suggest connecting a parallel printer directly to the
KE-350 in order to verify programming.
Suggested Initial Programming Steps
Step # Description
Page
1
Review System Defaults
7
2
Review System Options
8
3
Make changes in System Setup (Print to Verify)
13
4
Program the Time Clock (Print to Verify)
17
5
Program Holiday Schedule (Print to Verify)
16
6
Review Preprogrammed User Groups
19
7
Construct User Groups Worksheet
26
8
Modify User Groups as needed (Print to Verify)
20
9
Construct a list of Individual Users, Codes and User Groups
25
10
Program Individual Users (Print to Verify)
11
System Defaults
System Option
Default
Master Code
1 2 3
Door Open Time
5 seconds
Latching OFF
Use of Duress Codes
OFF
2
nd
Relay
Auxiliary Controller for 5 seconds
3
rd
Relay
CCTV/Light for 30 seconds
Automatic Line Feed (ALF)
ON
Daylight Savings Time (DST)
ON
Time Clock Setting *
Wed 01/01/1999 00:00:00
* Time Clock Setting Note: In order to preserve the internal battery life of the KE-
350’s Time Clock, the system is shipped from the factory in a “suspended clock”
mode. The Time Clock will remain suspended with the default setting until the Time
Clock is properly set through system programming (page 17). Failure to set the clock
may cause “Access Denied” for Individual Users and the Default Time Clock setting
in the Audit Trail Date and Time stamp.
7
