Keyautomation CT-724S, Instructions And Warnings For Installation And Use

Page: 23 / 88

23
EN
parameters Description Default min max unit type
1
Deceleration lenght
Determines how far in advance reduced speed is imposed to
the switch's stop.
50 0 200
cm
(step 10)
2
ramp acceleration and deceleration time.
the lower the value, the shorter and sharper is the ramp.
10 (30*) 10 30
3
impact force on obstacle: allows faster reaction time on the
obstacle (e.g. impact in the absence of rubber edge), lower
value = faster reaction time
50 0 100
4
further acceleration at start. useful to speed up the opening
of the barrier.
1 0 1 Ba
5
obstacle/edge reverse time (0 = disabled) 3 0 20 s sl
6
pedestrian opening lenght
Determines the partial opening of the installation from the
closeD position.
50 0 990
cm
(step 10)
sl
7 pedestrian opening automatic auto-reclosing time 20 0 600
s
(step 10)
sl
8
Photocell F2 configuration
0. enabled for both opening and closing op/cl
1. enabled only for opening op
0 0 1
9
enables opening with f1 obscured 1 0 1
10
Man Present configuration (only for open/close inputs)
0. 0. Disabled
1.
1. man present
0 0 1
11
clearance. allows to stop before the fully open position: it is
useful to avoid mechanical stress during opening.
0 0 100 Ba
12 Pre-flashing time 0 0 10 s
13
courtesy light timer 0 0 900
s
(step 10)
14
courtesy light configuration
1. on if courtesy light timer tcy is not expired
2. on if the gate is not tcy time
1 1 2
15
courtesy litht level at the end of the manouvre (0 = light is off,
other values light will stay on all the time at the desired level)
0 0 100
16
Open gate light configuration
0. on/off
1.
modulated by the position of the gate
2. magnetic electric lock function ( interface with a
24V external relay). to activate this function it is
necessary to activate also pre-flashing for 1 sec.
(tpr = 1)
0 0 2
17
cycles before maintenance (0 = disabled). When level set is
reached the next cycles will be done with a fast flashing to
advise the user
0 0 100
1000
cycles
18
Enables the constant flashing of the request for maintenance
(function performed only when the gate is closed)
Under battery back-up flashing will not be performed
0 0 1
19 number of encoder impulses per motor revolution 4 1 16 sl
20
sets default values and type of control
0. sliding
1. Barrier
2.
sliding 400 Kg (nep=1*) - lsi blocked at 50
0 0 1
To set the default values: 1) Enter the advanced programming 2) Select the "dEf" parameter 3) Activate the edit mode (displays "0" flashing)
4) Accept the change (press "MEnu" button for 2 seconds). At this point you should see a countdown d80,d79.....d02,d01
The ADVAnCED MEnu allows you to further customize the instal-
lation by changing some parameters not accessible from the basic
menu
To access the ADVAnCED menu, hold down the MEnu button for 5
seconds. To change the parameters of the ADVAnCED MEnu pro-
6 - INsIGhTs - ADVANCED MENU
ceed as indicated for the bASIC MEnu
In the last column are indicated the parameters used only for a
specific type of automation: SL sliding motor, BA barrier, BL over-
head, SE sectional.
* nEP value depends on motor encoder typology.
* Values for 400 Kg sliding motors.