7
The severed plug must be disposed of to avoid
a possible shock hazard and should never be
inserted into a mains socket elsewhere.
- Only for AUS and NZ Market: Use a residual
current device (RCD) with a rated residual
current of 30 mA or less.
3.Check before Use
While reading the operating instructions, unfold the
graphics page for the machine and leave it open.
1. Description of Functions
The numbering of the description of functions refers
to the illustration of the tool on the graphics page.
1. DUST COVER
2. TOO HOLDER COVER
3. BAND
4. GEAR COVER
5. HOUSING
6. ROTATIONAL DIRECTION SWITCH
7. SWITCH LOCK BUTTON
8. TRIGGER SWITCH
9. CHANGE LEVER
10. SIDE HANDLE
11. STOPPER HOLDER
12. BAND HOLDER
13. STOPPER
2. Applications
●
Boring into concrete.
●
Breaking up concrete.
●
Making hole for anchor bolt.
●
Consolidation, making groove, removal, etc.
[Example of Uses]
Cooling and heating work, piping and wiring work,
sanitary arrangements work, installation of
mechanism, water supply and drainage work,
interior work, steel structure installation, other civil
engineering equipment repair work.
3. Connection to Power Supply
4. The switch
Make sure the switch trigger is returned to its original
position by pushing it.
5. Extension Cord
Extended power cord may be used when the power
supply is located in a distant position, however its
length and thickness should be such that electric
current is not reversely affected. Too long or thin
power cord will cause too much voltage drop and
weakened motor driving force. Use a short power
cord as far as possible.
6. Power Supply Check
You must use the tool in the power source
specified
in the nameplate. When you use the tool for
110-127V~ in 220-240V~, the speed of the motor
will be increased abnormally.
In result, the Hammer drill bit and the tool may be
damaged.
7. An explanation of any symbols or
pictograms marked on the tool
relevant to safe use
GB
[
110-127 V~
]
[
230-240 V~
]
Nominal cross
section of
conductor
0.75 mm²
1.0 mm²
1.5 mm²
Nominal cross
section of
conductor
0.75 mm²
1.0 mm²
1.5 mm²
Max.
length
20 m
25 m
35 m
Max.
length
40 m
50 m
70 m
110-127 V~
230-240 V~
Damaged power cord should be changed or
repaired immediately.
Figure 1
n
o
V
A
Hz
W
/min
~
rated no-load speed
volts
amperes
hertz
watts
revolutions or reciprocations per minute
alternating current
Class II construction
Disposal of Old Electrical &
Electronic Equipment
130816 PHD-282B.283B(
).indd 7
2013-08-22 11:42:13
