KEY RK-2006LP, Operating Manual, Page: 22 / 40

22
Flame failure detection delay - this parameter specifies how long after the launch
procedures for the detection of flame failure or brightness temperature must remain
below the hysteresis for the regulator to decide that the furnace was extinguished.
F L A M E V A N I S H
D E L A Y 6 0 s
Fuel ignition time - after igniter and fan are switched on, the controller tests
temperature increase or brightness in the selected location of the burner. If flame is
not detected within the time programmed in this parameter, the controller will repeat
ignition cycle.
F U E L I G N I T I O N
T I M E 3 m i n
Ignition try count - this parameter specifies how many times ignition may fail until
the controller activates „Out of fuel alarm” and switches into STOP mode. The alarm
is indicated with adequate message displayed on the display. To start the controller
first refill the fuel, then cancel by pressing STOP button and start setting mode by
pressing START button.
I G N I T I O N T R Y
C O U N T 2
Kindle fire stabilize – the parameter determines if the mode of kindle fire stabilize is
switched on after the fuel has been ignited.
K I N D L E F I R E
S T A B I L I Z E Y E S
Kindle fire stabilize time – the parameter defines the maximum working time while
the regulator is in the mode of stabilizing the ignition. The parameter is not available
if the „Kindle fire stabilize” parameter has been set to „NO”.
K I N D L E F I R E
S T A B . T I M E 5 m i n
Smooth kindle fire stabilize – set the parameter to the “YES” value to allow the
regulator to increase the amount of fuel gradually while it is in the „Kindle fire
stabilize” mode. The parameter is not available if the „Kindle fire stabilize” parameter
has been set to „NO”.
S M O O T H K I N D L E
F I R E S T A B I L . Y E S