Key West Boats 1720CC, Manual

Page: 27 / 56

(if equipped), at the switch panel, or at the cranking battery. Trolling motors
are protected with an in-line fuse located in the positive (red) lead at the
trolling motor battery. Fuse sizes vary depending on model, check with
your Key West dealer for correct size.
♦ CAUTION ♦
Do not exceed the recommended fuse sizes. Always install
the proper (type and rating) fuses whenever replacing
or changing fuses. Continuous fuse failures indicate a
severe problem and requires immediate attention. Failure
to install the correct fuse may result in damage to the
electrical system or severe personal injury.
On models equipped with a stereo, an in-line fuse is located in the positive
lead at the rear of the stereo. If equipped with a depth finder, the in-line
fuse is located under the console (if equipped) or near the unit.
SWITCHES AND CONTROLS
All switches used are either two or three-position rocker types. Many
switches have red LED indicators for positive ON/OFF identification.
Lights (Navigation and Anchor) Switch
Three-position switch that controls the running lights.
• NAV position will turn on the red and green bow lights, white stern
light and gauge illumination lights for night operation.
• ANC turns on stern light only for night anchoring (do not operate the boat
with switch in ANC position).
• OFF is center position.
Bilge Switch
Two-position ON/OFF switch that activates the bilge pump to remove
excess water in the bilge.
Aerator Switch
Two or three-position switch that activates the aerator pump to add water
to the live well.
• MANUAL (or “ON”) position is used to continuously add water to the live well.
• AUTO position (if equipped) is used when fishing and cycles the pump
one minute ON and three minutes OFF to conserve battery power.
• OFF is center position {three position switch only).
22