Key Digital KD-SX440WP, Operating Instructions Manual

Page: 7 / 12

10 11
IR Out: Connect IR Emitter (included) and mount over IR sensor of desired device
to be controlled.
➔
Corresponds with IR from the IR sensor of the wall-plate Tx
➔
3.5mm Mono
»
Tip = IR Signal (5V)
»
Sleeve = Ground
RS-232 Terminal:
Connect with control system for pass-thru of bi-directional RS-
232 commands.
➔
RS-232 Pass-through Mode: Send and receive (bi-directional) RS-232
commands for controlling remote equipment. Supports baud rate up to
115,200bps.
Power, Link, Video LEDs:
Indicate system connectivity status
➔
Power ( green ) illuminates solid with proper powering from power supply
➔
Link ( blue ) illuminates solid from healthy HDBaseT connectivity with Tx unit
➔
Video ( orange ) illuminates solid with active HDCP encrypted AV signal.
Blinks steadily if source is not encrypted with HDCP.
KD-SX440Rx Unit:
HDMI Output: Using an HDMI cable, connect your HDMI display or system.
For DVI-D/DVI-I sources, use appropriate adapters. For Display Port, use active
adapters.
➔
Compliant with HDCP 2.2 and previous
➔
Maximum input resolution: 4096x2160 60Hz [4:2:0] 8bit, 4096x2160 30Hz [4:2:2]
12bit, and 4096x2160 30Hz [4:4:4] 8bit
➔
Supports lossless compressed audio formats including Dolby ® TrueHD,
Dolby
®
Digital Plus, Dolby Atmos
®
, and DTS-HD Master Audio
™
➔
Supports CEC
HDBaseT Input: Connect a CAT5e/6 cable to the Tx Unit at the port labeled
“HDBaseT Output”.
➔
UHD/4K: Up to 230 ft. (70m) using CAT5e/6
Up to 328 ft. (100m) using CAT6A STP / CAT7
➔
1080p: Up to 328 ft. (100m) maximum
➔
Must connect with KD-SX440WPTx only.
Not compatible with third-party HDBaseT Tx.
Power: 24V 1.67A (40W) Power Supply.
➔
Provides power to Tx unit