Page 16
To Mute Output - Analog Audio Only:
»
‘SP O xx A E/D/T’
To Mute the Analog Audio Output for a specific Output:
»
Where xx = ‘01-99’ and is the Output number and ‘E’ is for Audio Mute Enabled, ‘D’ is for
Audio Mute Disabled and ‘T’ is to toggle between Enabled and Disabled.
»
Example:
To Enable Audio Mute for Output 3, issue the command;
‘SPO03AE’
To Mute Output - PCM Audio Only:
»
‘SP O xx PM E/D/T’
To Mute the PCM audio for a specific output;
»
Where xx = ‘01-99’ and is the Output number, and ‘E’ is for Audio Mute Enabled, ‘D’ is for
Audio Mute Disabled and ‘T’ is to Toggle between Enabled and Disabled.
»
Example:
To Enable PCM Audio Mute for Output 3, issue the command;
‘SPO03PME’
»
NOTE:
This command will also mute Composite Video if utilized at the PCM connections
To Mute Output – Video & Audio:
»
‘SP O xx AVM E/D/T’
To Mute the Video & Audio Output for a specific Output;
»
Where xx = ‘01-99’ and is the Output number and ‘E’ is for Video & Audio Mute Enabled, ‘D’
is for Video & Audio Mute Disabled and ‘T’ is to toggle between Enabled and Disabled.
»
Example:
To Enable Video & Audio Mute for Output 3, issue the command;
‘SPO03AVME’
To switch Video and Audio together:
»
‘SP O xx S yy’
To rout the desired Input to the desired Output with Audio:
»
Where xx = ‘01-99’ and is the Output number and yy = ‘01-99’ and is the Input number.
»
Example:
To route Input 3 with audio to Output 2 issue the command;
‘SPO02S03’
To switch Video only:
»
‘SP O xx SI yy’
To rout the desired Video Only Input to the desired Output:
»
Where xx = 01-99 and is the Output number and yy = 01-99 and is the Input number.
»
Example:
To route Input 3 to Output 2 issue the command; ‘
SPO02SI03’
To switch Audio only:
»
‘SP O xx SA yy’
To rout the desired Audio Only Input to the desired Output:
»
Where xx = 01-99 and is the Output number and yy = 01-99 and is the Input number
»
Example:
To route Audio Input 3 to Output 2 issue the command; ‘
SPO02SA03’
To switch PCM Audio (or CV) Only:
»
‘SP O xx SP yy’
To rout the desired PCM Audio (or Composite Video) to the desired Output:
»
Where xx = ‘01-99’ and is the Output number, and yy = ‘01-99’ and is the Input number.
»
Example:
To route PCM from Input 3 to Output 2, issue the command;
‘SPO02SP03’
System Control Set-Up Commands
Front Panel Buttons:
»
‘SP C FB E/D/T’
To Enable or Disable the Front Panel push buttons for the unit;
»
Example:
To Enable the front panel buttons issue the command;
‘SPCFBE
»
Example:
To Disable the front panel push buttons issue the command;
‘SPCFBD’
»
Example:
To Toggle between front panel buttons enable-disable issue the
command
‘SPCFBT’
