Key Digital KD-FIX418A, Operating Instructions Manual

Page: 7 / 10

10 11
Help Command (H). Returns entire API in readable format:
KD-FIX418A> H
-------------------------------------------------------------------------
-- Key Digital Systems HELP --
-------------------------------------------------------------------------
-- KD-FIX418A System Address = 00 F/W Version : 1.00 --
-- --
-- Azz : All Commands may have Prefix System Address zz=[01-99] --
-- H : Help --
-- STA : Show Global System Status --
-- --
-- Video Output Setup Commands: --
-- SPO ON/OFF : Set Output 01 ON/OFF --
-- SPO DBG ON/OFF : Set Debug Mode ON/OFF --
-- --
-- Audio Output Setup Commands: [E=Enable, D=Disable] --
-- SPO AA E/D : Enable/Disable External Analog Audio Output --
-- SPO DA E/D : Enable/Disable External Digital Audio Output --
-- --
-- System Address Setup Command: xx = [00-99], 00 = Single --
-- SPC Axx : Set System Address to xx --
-- --
-- System Control Setup Commands: --
-- SPC RSB z : Set RS232 Baud Rate to z bps, z=[0-4] --
-- [0:57600, 1:38400, 2:19200, 3:9600, 4:4800] --
-- SPC DF : Reset to Factory Defaults --
-------------------------------------------------------------------------
RS-232 Commands
KD-FIX418A allows control over serial interface for bi-directional communication.
Use a TRS cable for RS-232 communication.
Pin Out:
»
Tip = RS-232 Tx Data
»
Ring = RS-232 Rx Data
»
Sleeve = RS-232 Ground
Connection Protocol:
»
Baud Rate = 57,600 bits per second
»
Data Bits = 8
»
Stop Bits = 1
»
Parity = Non
»
Flow Control = None
»
Carriage Return: Required at end of string
Notes:
»
Commands are not case-sensitive
»
Spaces are shown for clarity; commands should NOT have any spaces
»
After a new command is received, a prompt should be sent back
Status Command (STA). Returns unit status and settings in readable format:
KD-FIX418A> STA
-------------------------------------------------------------------------
-- Key Digital Systems STATUS --
-------------------------------------------------------------------------
-- KD-FIX418A System Address = 00 F/W Version : 1.00 --
-- --
-- RS232 : Baud Rate=57600bps, Data=8bit, Parity=None, Stop=1bit --
-- --
-- Video Input : EDID = DEFAULT 00, LINK = ON --
-- Video Output : Output = ON , LINK = ON , DBG = OFF --
-- Audio Output : Analog = Enabled, Digital = Enabled --
-------------------------------------------------------------------------