7
6
SECTION 1
Setup & First Brew
Setting up Your Brewer
1.
Remove all pieces of packing tape from
the brewer and Drip Tray. Remove the
clear plastic film from the LCD Screen.
Unwrap the Power Cord and plug the brewer
into a grounded outlet.
2.
Turn the brewer on, the Power Switch is
located at the top left hand side of the brewer
on the back. The brewer’s LCD Screen will
display the power up welcome screen (fig. 1).
3.
Remove the Water Reservoir from the brewer
by first removing the Water Reservoir Lid,
then lifting the Water Reservoir straight up
and away from the brewer (may be tight).
Rinse with fresh water.
IMPorTanT:
You cannot use your Keurig
®
brewer
until it has been set up for its first use.
noTe:
If the brewer has been exposed to
temperatures below freezing, allow the brewer at
least two hours to reach room temperature before
brewing. A frozen or extremely cold brewer will
not operate.
4.
Fill the Water Reservoir to and
not beyond the MAX FILL line
with bottled or filtered water.
Replace the Water Reservoir on
the brewer making sure that the
locking tabs engage with the
brewer (fig. 2). Replace the
Water Reservoir Lid on the
Water Reservoir.
5.
The brewer will automatically fill
the internal water tank with
water and then the water will be
heated. This will take about
3 minutes. During the heating
period, “HEATING PLEASE
WAIT” will be displayed on the
LCD Screen (fig. 3).
6.
Place a 10 oz. mug on the Drip
Tray Plate, then lift and lower
the Handle. The BREW Button
will now be illuminated. Press
the BREW Button to start
a cleansing brew.
NOTE:
A
K-Cup
®
pod should not be used
for this sequence.
fig.
1
fig.
2
Welcome To The
Keurig
®
150 Brewing
System Designed
For The K-Cup
®
Pod
Español
Français
fig.
3
Heating...
Please Wait
P6 20162461 T5274_K150_UCG_FINAL.pdf 4C(CMYK) ZB2319 2016-11-02 Size:8.5X5.5in
