5
Montaż
5.1
Informacje ogólne na temat montażu
Urządzenie należy wyposażyć w zabezpieczający elektrycznie bezpiecznik różnicowo-prądowy.
Urządzenie sterujące należy ustawić w takim miejscu, aby nie mogło dojść do jego nieupoważnionego użycia.
W przypadku niezamierzonego wyłączenia urządzenia może dojść do szkód następczych w budynku.
Kolejność montażu
Urządzenie jest montowane i uruchamiane w różnym czasie odpowiednio do etapów budowy.
Montaż zbiornika urządzenia z przyłączem na dopływ ścieków, odpowietrzaniem i przewodem tłocznym, poprzez który
patrz "Ustalenie zbiornika urządzenia", strona 99
Montaż urządzenia sterującego i przyłączenie komponentów elektrycznych (
patrz "Montaż urządzenia sterującego",
Pierwsze uruchomienie (
patrz "Uruchomienie urządzenia", strona 103
).
5.2
Ustalenie zbiornika urządzenia
Ustawić zbiornik urządzenia we właściwej pozycji i przy-
kręcić śrubami w dwóch miejscach mocowania (1) do
podłoża. Śruby mogą mieć rozmiar maksymalnie M8.
Dobrać środki mocujące w taki sposób, aby w każdym
punkcie mocowania możliwa była siła uciągu minimum
200 N.
Aby zminimalizować przenoszenie dźwięków, użyć pod-
kładu do izolacji dźwiękowej KESSEL.
5.3
Montaż dopływu i odpływu
Przygotowanie
Niebezpieczeństwo zakłóceń funkcji przez zbierające się
na czujniku poziomu zawiesiny i/lub ciała stałe.
Dopływ na króćcu (2)
Skrócić króciec w odpowiednim miejscu.
Dopływ na króćcu (6)
Skrócić króciec w odpowiednim miejscu.
Zamienić czujnik poziomu (3) z pokrywą otworu serwiso-
wego (5).
Wykręcić 4 śruby mocujące (4) i odpowiednio prze-
montować obydwa podzespoły.
Ustawić przy tym zabezpieczenie przed przekręce-
niem (1) w odpowiedniej pozycji.
PL
010-974
Przepompownia / Instrukcja zabudowy i obsługi
99 / 112
Summary of Contents for aqualift f
Page 110: ......
Page 111: ...010 974 111 112...