Kesseböhmer FREEflap eTouch, Translation Of The Original Operating Instructions

Page: 15 / 32

15/15
H
D
E
K
E
1
12.
000
1.0
10.
428.
00
00.
00
40
37240
000
7.3 Battery change
» For step by step instructions, see picture section on page 30 , point 7.3.
8. Disposal
» Please comply with the respective national and local regulations when
disposing of or recycling the fitting or its components!
9. Troubleshooting
10. Technical data
NOTE
» Dispose of old battery in an environmentally friendly manner.
Problem Cause Remedy
Not working Mains voltage not present Check whether power plug
has been inserted
Plug connections have no
contact Check all plug connections for
proper contact
After 2 minutes of
continuous operation -
stop for 8 minutes Wait for 8 minutes
Unable to perform
reference run Push-button sender / drive
unit coordination not car-
ried out Perform push-button sender
coordination, see chapter
4.1
Teach in push-button sender
Battery in push-button
sender empty, not present
or wrongly inserted Insert new battery or check for
correct installation position,
see chapter
7.3 Battery
change
Reference run starts
but is not completed Force setting of fitting does
not match flap weight Perform force setting as per
point 12 of the Free flap fitting
installation instructions
Reference run re-
starts Power failure Perform reference run, see
chapter
5.1 Initiating a new ref-
erence run
NOTE
» Contact your specialist dealer if the fitting is still defective after performing the
described remedial measures or other problems arise.
Voltage / frequency / current strength 100 - 240 V AC / 50 - 60 Hz / 1.3 A
Wattage 60 Watt
Ambient temperature range 0 - 40 °C
Overvoltage category Degree of protection 3
Protection type / degree of protection IP2X / degree of protection 2
Radio frequency 2.4 GHz
Battery CR 2032 Lithium button cell, 3 V
Standby power ≤ 1 Watt
BA_MA_Free-Kesseböhmer.book Seite 15 Freitag, 12. Juni 2015 9:50 09