H
D
E
K
E
1
12.
000
1.0
10.
428
.00
00.
00
40
37240
000
12/15
Acoustic feedback
A signal is emitted after every action.
Visual feedback
Every action is completed by flashing or illumination of the LEDs.
Operations
4.1 Teach in push-button sender
» For step by step instructions, see picture section on page
, point 4.1.
» Repeat procedure for all push-button senders that are assigned to the drive unit
(usually two push-button senders).
» Continue to next menu item or complete setup, see section "
up by carrying out an automatic reference run
NOTE
An activated menu item remains active for 30 seconds, then the setup menu is
automatically exited.
Confirmation
A step that was learned during teach-in or
programming has been confirmed.
Cancel
The previous step has been cancelled.
Next menu item
The next menu item has been reached.
Warning
Warning signal in the event of a malfunction or
erroneous operation.
LED permanently on
LED flashing
LED permanently off
Green LED
Menu selection
switching but-
ton
• Long press > 2s
Setup start / Activate
menu item
• Extremely short press < 100 ms
Next menu item
Red LED
NOTE
A push-button sender can only be taught in at one drive.
After selecting the menu item, the push-button sender must be pressed within
30 seconds. A successful teach-in is confirmed by an acoustic signal.
BA_MA_Free-Kesseböhmer.book Seite 12 Freitag, 12. Juni 2015 9:50 09
