KERR SonicFill 2, Directions For Use Manual

Page: 4 / 40

2
The Unidose™ tips are designed for SINGLE PATIENT USE ONLY to
prevent cross-contamination between patients.
Note that SonicFill 2 has somewhat higher translucency than other
composites to facilitate a greater depth-of-cure (5 mm). This
translucency may limit clinical applications in some class IV
restorations or other anterior applications where the restorative
material is not surrounded by tooth structure. In these instances,
please check to make sure the translucency meets esthetic
requirements before bonding the composite material.
Adverse Reactions
None known.
Instructions for Use
SonicFill Handpiece
The SonicFill Handpiece is packaged with a Use and Care guide. To
receive the best use from your Handpiece, read and follow the use
and care instructions included with the device.
Using SonicFill 2
Setup
1. Select the desired shade. If Class II, place matrix of choice.
2. Verify air pressure of dental unit is between 40 and 70 PSI (276
kPa – 483 kPa).
3. Accurately position the Handpiece on the coupling and press it
firmly until securely (audibly) locked.
4. Remove red protective covers from tip by pulling them straight
off without twisting to prevent disassembling the tip. Discard
any disassembled tips.
5. Insert Unidose capsule with moderate pressure and rotate
SonicFill Handpiece into tip in a clockwise direction – this will
screw tip into place. If the tip will not screw on easily, it has
likely cross-threaded. Unscrew the tip and start again. If you
are not able to easily screw the tip onto the handpiece, discard
the tip.
6. Once tip has been placed on handpiece, remove red cover at
the end of the tip.