Kero-Sun LC-45, Instruction Manual

Page: 11 / 33

ENGLISH
11
10
SET ALTITUDE
1. If the heater is used at a height of 800 m to 1300 m, use the
altitude mode 1. Push the altitude button with thin rod like a
clip and plug into the outlet simultaneously. Then “
1
” will be
shown on the display.
2. If the heater is used at a height of 1300 m to 1900 m, use the
altitude mode 2. After setting the altitude mode 1, push the
altitude button with thin rod and plug into the outlet
simultaneouosly again. Then “
2
” will be shown on the
display.
3. Switch off the altitude mode by pressing the altitude button
and into the outlet simultaneously after setting altitude mode
2. Then “
0
” will be shown on the display and “ ” will be
disappeared.
NOTE: When the altitude mode 1 is set, the altitude mark “ ” is lit on the display.
When the altitude mode 2 is set, the altitude mark “ ” is blinking during operation.
NOTE: In the event of power failure or disconnection of heater, the altitude setting will
remain.
!
Do not use the heater at a height of over 1900 meters.
SWITCH THE VOLUME
This heater can be switched the buzzer sound volume. The initial setting is in High level.
1. Push the SAVE key and holding it down for more than 3 seconds, then the buzzer sound
volume is switched from High to Low.
2. Push the SAVE key and holding it down for more than 3 seconds again, then the buzzer
sound volume is switched from Low to High.
NOTE: The volume level is Low and High only, but the alarm by safety device sounds in
High level.
NOTE: When the heater has been unplugged or after a power failure, the volume will be the
initial setting High.