EN
40
Programator
operation and oven control
Programator
symbols:
Setting the time:
After energizing the oven, timer will be reset to 0:00
and this setting will be blinking.
•
Press and hold MENU
(or simultaneously
touch
<
/
>
) until you will see on the
display and the
dot below the symbol is
flashing,
•
Touch
<
/
>
7 seconds to set the current
time.
MENU
-
select the mode of operation
- sensor Plus
-
sensor Minus
-
appliance on indicator
-
Timer indicator
-
Duration
-
End Time
To store the new time setting, wait approximately 7 seconds after time has been set. The dot below
the symbol will stop flashing.
You can adjust the time later. To do this touch
<
/
>
simultaneously and adjust the current time while the dot
below the
symbol is flashing.
Warning
The oven can be operated only after
symbol appears on the screen.
T
imer
:
Timer can be set at any time, regardless of other functions. It can be set
from 1 minute up to 23 hours and 59 minutes.
To set the timer, you should:
•
touch MENU, then the display will show blinking :
•
use the < / >, sensors to set th
e
Timer. The display will show the set time and
Timer
symbol
. Once the set time elapses, alarm sounds and the icon
flashes,
•
Touch and hold < / > or MENU to mute the alarm. The will be off and the
display will
show the current time after approximately 7 seconds
Note:
Audible signal will turn off after 7 minutes if no sensors are touched.
Semi-automatic operation:
If you would like your oven to shut down after a certain time:
