KERN PEJ, Operating Manual

Page: 54 / 86

PES/PEJ-BA-defsi-0510 141
There are two different ways to set the tolerance limits:
1. Place the values (object) on the balance -
> Save this value
2. Numeric entering of values -
> Enter the limits via keyboard.
NOTE:
If a limiting value was set it remains saved until the balance is turned off.
For the functions weighing, counting, percent individual limits can be set.
When entering the limits please pay attention to the type of evaluation that was set.
12.2. Display of the results
12.2.1. For 2 limits
The triangular tolerance marker ( ) in the upper part of the display shows whether
the goods to be weighed are within the two tolerance limits.
The tolerance marker is only in operation during operating mode tolerance weighing;
it is otherwise not visible.
The tolerance marker provides the following information:
Goods to be weighed above tolerance limit
Goods to be weighed within tolerance range
Goods to be weighed below tolerance limit
Display
Result
If a point is set as lower
limit
If two points are set as upper and
lower limit
+ (high) No display Weight > Upper limit
TOL (OK) Lower limit Weight Lower limit Weight Upper limit
- (low)
Lower limit > Weight Lower limit > Weight