KERN DE120K10A, Operating Instruction

Page: 56 / 376

DE-BA-e-1052 18
6.3 Taring
Switch-on the balance using the key and wait for the „0“ display.
Put the tare vessel on the weighing plate and press the key. The balance
display goes to „ 0 “. The weight of the container is now internally saved.
If after finishing the weighing process the key, is pressed again, „ 0 “ appears
anew in the display.
The taring process can be repeated any number of times, e.g. when adding several
components for a mixture (adding).
The limit is reached when the whole weighing range is exhausted.
After removing the taring container the total weight is displayed as negative display.
6.4 PRE-Tare function
Using this function the weight of a tare vessel can be stored.
This value also remains saved if the balance meanwhile has been switched off and
switched on again.
Switch-on balance using the key and wait for the „ 0 “ display.
Put tare vessel on the weighing plate and press the key 6 times until „PtArE“
flashes on the display. By actuating the key, the current weight on the weighing
plate is saved as PRE-Tare weight.
To switch off this function, unload the weighing plate and press the key 6 times,
until „PtArE“ flashes on the display. Then press the key. The stored PRE-Tare
weight is deleted.
6.5 Plus/minus weighings
For example unit weight control, fabrication control etc.
Switch-on the balance using the key and wait for the „0“ display.
Put the nominal weight on the weighing plate and tare to „ 0 “ using the key.
Remove the nominal weight.
Put the test objects subsequently on the weighing plate, the respective deviation from
the nominal weight is displayed with the respective sign to „+“ and „-“.
According to the same procedure also packages with the same weight can be
produced, referring to a nominal weight.
Back to weighing mode by pressing the key.