KERN AEJ_N, Operating Instructions Manual

Page: 67 / 85

AEJ_N/AES_N-BA-e-1321 67
13.6.2 Carry out series of measurements for test volume V
0

After entering all parameters (See chap. 13.6.1), position the weighing vessel,
wait for the stability display to appear, then tare by pressing the
TARE -key; P1
V
0
will appear, followed by Place 1 .
1. Dispense the test fluid (such as distilled water) into the weighing vessel of
conduit “
V
0
”.
2. Wait for stability display, then press the PRINT button. Place 2 followed by
the current weight display will appear.
3. Tare, by pressing the TARE -key.

Repeat this test cycle (steps 1 -3) as often as set in “ Set n ”
(see chap. 13.6.1).

After the last test cycle has been confirmed, a display announcing the start of
the second series of measurements “
P2 V
1/2
”, followed by Place 1 , see chap.
13.6.3, will appear.