SB-593 Satellite Board
Unit 17 Park Farm Industrial Estate
01925-001 Rev. 1.2
Buntingford, Herts SG9 9AZ UK
TEL: 0870 444 7234 FAX: 0870 444 7240
Web: http://www.kerisystems.co.uk E-mail: [email protected]
Page 4 of 16
Quick S
tart Guide
SB-593
5.0
Board Installation
Perform the following steps to install an SB-593 Satellite board on a PXL-250 or PXL-500/PXL-510 controller
(see Figure 3).
1.
Turn the controller's power OFF.
2.
Line up the upper left-hand corner of the Satellite PCB with the controller PCB.
3.
Line up the stand-offs in the top two corners of the Satellite PCB with corresponding mounting holes in the
controller PCB (see Figure 3).
4.
Align the Satellite Board’s connector pins to the PXL’s mounting holes.
NOTE: If you are installing the SB-593 (which has two rows of connector pins) on a PXL-250 controller (which has
one row of mounting holes) it does not matter which row of connector pins are inserted in the mounting holes.
5.
Gently press the two boards together with each stand-off into its mounting hole and with the connector pins
meshing together with their mounting holes.
6.
Turn the controller’s power ON.
7.
If the P2 mounting holes have the PXL’s J2 connector pins inserted correctly, the Power LED6 will illuminated
and remain so as long as the connection continues and power is supplied to the unit.
8.
If the P3 mounting holes have the PXL’s J3 connector pins inserted correctly, the SDA LED5 will flicker and
continue to do so as long as the connection continues and power is supplied to the unit.
Figure 3: SB-593 Board Installation
6.0
Connecting Wires - Removing a Terminal Block
Figure 4: Connecting Wires to Terminal Blocks
