JQE SPECIAL SVC 092611
7-1
SECTION 7 - ELECTRICAL PARTS LIST AND DIAGRAMS
7.1
GENERAL
This section contains the schematic diagrams, the parts location diagrams, and a list of all
replaceable electrical parts. All components are listed in alpha-numerical order of their refer-
ence designations. Consult your Kepco Representative for replacement of parts not listed here.
7.2
ORDERING INFORMATION
To order a replacement part or inquire about parts not listed in the parts list, address order or
inquiry either to your authorized Kepco Sales Representative or to:
KEPCO, INC.
131-38 Sanford Avenue
Flushing, NY 11355
Specify the following information for each part:
• Power Supply Model number, Serial number, and Revision number stamped on the
nameplate of the unit.
• Kepco part number. See Parts List.
• Circuit Reference Designation. See Schematic Diagram.
• Description. See Parts List.
To order a part not listed in the parts list, give a complete description and include its function
and location.
NOTE:
Kepco does not stock or sell complete power supply subassemblies as described here
and elsewhere in the instruction manual. Some of the reasons are listed below:
1.
Replacement of a complete subassembly is a comparatively rare necessity.
2. Kepco's subassemblies are readily serviceable, since most of them are the "plug- in"
type.
3.
The nature of a closed loop power supply system requires that subassembly replace-
ment be followed by careful measurement of the total power supply performance. In
addition, depending on the function of the subassembly, extensive alignment may be
required to restore power supply performance to specified values.
If repairs involving subassembly replacements are required, please contact your local Kepco
representative or the Kepco Sales Engineering department in Flushing, New York, NY.
