14
Operation
Countertop Preparation
3
Your Texan Grill with Knob Control is
supplied with a factory installed polished
stainless steel flange that accepts nine oval head
wood screws for mounting. The trim flange of the
grill is designed to hold the unit firmly in place in
the countertop. If desired, you may seal the edge
of the countertop beneath the trim flange. We
recommend a
NON-ADHESIVE
such as
Plumbers Putty. This will help reduce the chance
of damage to the trim flange should the unit
need to be removed from the countertop. Should
you need to remove the unit from the countertop
after installation simply take a piece of fishing
line and run back and forth under the trim flange
to break the caulk bond.
D
- 30 inches minimum clearance between the
top of the cooking surface and the bottom of an
unprotected wood or metal cabinet or 24 inch
minimum clearance when the bottom of the
wood or metal cabinet is protected by not less
than 1/4-inch-thick flame retardant millboard
covered with not less than No. 28 MSG
sheet steel, 0.015-inch-think stainless steel,
0.024-inch-thick aluminum or 0.020-inch-thick-
copper.
E
- 6-inch minimum from backsplash of
countertop to edge of grill(refer to
page 5
for
overall grill dimensions). 1-1/2 inches minimum
from front of counter to grill.
It is important to plan ahead for installation of
the grill, keeping the following dimensions in
mind.
A
- 13 inches maximum depth of overhead
cabinets
B
- 36 inches is minimum height of
countertop above floor
C
- The minimum flat countertop surface that the
grill will rest upon must be equal to or greater
than the overall grill dimensions (refer to
page 5
for overall grill dimensions).
FOR INSTALLATIONS IN CANADA
:
“Do Not Install Closer Than 1/2 Inch
(12mm) From Any Adjacent Surface”, and
NE PAS INSTALLER A’MDINS DE 12MM
DETOUTE SURFACE ADJACENTE.
WARNING!
Allow a 2 inch (2”) minimum clearance
between the bottom of the grill and
combustible surface located below, ie:
the upper edge of a drawer installed
below the grill (see page 18). Failure
to provide proper clearances and
ventilation may result in a fire hazard.
PLEASE READ THIS SECTION PRIOR TO
MAKING CUTOUT FOR THE GRILL.
