Removing the Hard Rubber Frame
■
Catch
Lock
Accessory
E
Catch facing up
Engage the catch pins on the removal
tool and remove the two locks on the
lower level.Lower the frame and pull it
forward as shown in the figure.
When the lower level is removed,
remove the upper two locations.
The frame can be removed from the top
side in the same manner.
NOTE
2
1
Refer to the section “Removing the Hard Rubber
Frame” and then remove the hard rubber frame.
Remove the screw (M4
×
8 ) on the back panel.
Insert the two removal tools deeply into the slots on
each side, as shown.
Lower the removal tool toward the bottom, and pull
out the unit halfway while pressing towards the
inside.
Be careful to avoid injury from the catch pins on the
removal tool.
Pull the unit all the way out with your hands, being
careful not to drop it.
5
2
CAUTION
4
3
2
1
Removing the Unit
■
7
Removing the Unit
VZ-7000_B54_Eng 02.3.26 6:43 PM Page 7
