5
Installing and Connecting the Antenna Units
• Attach the antenna to the inner glass surface of the rear window using double-sided tape. Carefully
check the installation location as the tape can only be stuck on once.
• If the surface temperature of the glass of the rear window is low, warm it by turning on the power of
the rear defogger.
A cold window glass surface will weaken the adhesive strength of the double-sided tape.
Also, if installation inside the cabin is performed on a day with high humidity or when it is raining, the
high humidity level will weaken the adhesive strength of the double-sided tape.
• Do not install the antenna in a location where it may obstruct the field of view during driving, such as on
the windshield.
Check the location where the antenna is to be
attached.Clean off any grease or dirt from the
installation location using the supplied glass
cleaner
(Accessory
G
)
, clean the area with water
and allow to dry.
Clean the glass thoroughly as failure to clean the
glass can not only weaken the adhesive strength
of the double-sided tape, but may also cause it to
come loose.
Remove the protective strips from the antenna
parts and the back of the antenna unit.
Attach the double-sided tape of the antenna parts
and the antenna unit to the rear windshield glass.
Attach the double-sided tape by firmly pressing
down from the top. Secure cables using the
supplied clampers.
After attaching the antenna with the double-sided
tape, allow it to sit undisturbed for 24 hours. Take
care not to apply force to the antenna or allow it to
get wet during this time.
Wire the antenna cable to the main unit.
5
4
3
2
2
CAUTION
1
Rear seat
Rear window
Bundle cables with the
clamper bar
(Accessory
H
)
Antenna parts
Antenna unit
–
+
To the main unit
Ignition cable (Red)
ª
12V
Ignition key switch
Car fuse box
(Main fuse)
ACC
Ground cable (Black)
·
(To car chassis)
Battery
Incar antennas have a lower reception sensitivity than antennas intended for outside mounting. The
picture may not appear or may be disturbed if the signal in your area is weak.
2
CAUTION
Fuse(1A)
VZ-7000_B54_Eng 02.3.26 6:43 PM Page 5
