Kenwood VZ-5000, Instruction Manual

Page: 17 / 80

English 17
Removing Monitor Unit
Removing the Hard Rubber Frame
■
Engage the catch pins on the removal tool and remove
the two locks on the lower level.
Lower the frame and pull it forward as shown in the
figure. When the lower level is removed, remove the upper
two locations.
The frame can be removed from the top side in the
same manner.
2 1
Catch Lock
(Accessory
E
)
Refer to the section “Removing
the Hard Rubber Frame” and then
remove the hard rubber frame.
Remove the screw (M4
¥
6) on the
back panel.
Insert the two removal tools
deeply into the slots on each side,
as shown.
Lower the removal tool toward
the bottom, and pull out the unit
halfway while pressing towards
the inside.
Be careful to avoid injury from
the catch pins on the removal
tool.
Pull the unit all the way out with
your hands, being careful not to
drop it.
5 4
3
2
1
Removing the Unit
■
Catch facing up
English