Kenwood UBZ-LJ9SETE, Instruction Manual

Page: 35 / 120

15
4.9 Battery charge level
The battery charge level is indicated by bar symbols. In addition, a signal tone sounds when the
battery level is low and the charge indicator flashes red.
To display the battery charge level, please proceed as follows:
• Press
9 x long
on the
<Function key up>
, key and the current charge level is shown in the
display.
• Press the
<PTT key>
exits the settings menu and the transceiver is back in reception mode.
4.10 Monitor function
The monitor function can be used to receive weaker signals on the current channel. You can activate
the monitoring as follows:
• By briefly pressing the
<Function key down>
key the function can be switched On and Off.
Note:
The monitor function works independently of the set QT/DQT code.
4.11 Channel search (Scan)
With the channel search you can search for active channels. If a corresponding channel is found, the
search stops and communication is played back. If the transmission ends on the found channel, the
channel search is automatically continued.
To start the channel search, please proceed as follows:
• Press
1 x long
on the
<Function key down>
, key and the search from channel 1 to channel 16
(or channels 1 to 32, depending on the setting) will start.
• If you briefly press the
<Function key up>
or
<Function key down>
keys during the search, the
sequence of the search is reversed.
Note:
If you press the
<PTT key>
while listening to a found channel, the transceiver will return to
standby mode on the current channel.
4.12 Energy saving function
If the transceiver is not used for more than 10 seconds, it automatically switches to energy-saving
mode. This has no effect on the reception of transmissions and the normal mode is automatically
reactivated as soon as a signal is detected.
Battery fully charged
Battery 2/3 charged
Battery 1/3 charged
Battery empty