TK-8302/8302H
8
1. Disassembly Procedure
1. When removing the cabinet, fi rst remove the two screws
from the right and left with a phillips screwdriver.
Then, hook your fi nger on the edge of the cabinet and
pull it out until it is over the chassis protrusion. Remove
the cabinet by prying the cabinet as shown below.
Cabinet
2. To remove the panel assembly, fi rst turn the transceiver
upside down.
Then, insert a fl at-head screwdriver into the holes of the
chassis and tilt it in the direction as shown by the arrow.
Panel assembly
Holes
3. Disconnect the fl at cable from connector of the panel as-
sembly.
Flat cable
4. To remove the speaker holder, first remove the two
screws from the display PCB using a phillips screwdriver.
Then, insert a fl at-head screwdriver under the tabs of the
speaker holder and tilt it in the direction shown by the ar-
row.
Remove the speaker from the front panel by turning it in
the direction indicated, together with the speaker holder
and display PCB.
Speaker
holder
Tabs
Display PCB
5. When removing the TX-RX PCB, first remove the top
packing.
Then, remove the solder of the antenna hot pin and posi-
tive terminal of the DC cord.
Remove the 15 screws from the TX-RX PCB, power
module, and audio amp.
Positive terminal
of the DC cord
Antenna hot pin
Power module
Top packing
TX-RX PCB
Audio amp
DISASSEMBLY FOR REPAIR
