7
SCAN
To activate the Scan function, press the key programmed as
Scan On/ Off
.
• The indicator next to the programmed key flashes (“
” or “
”).
When a signal is detected on a channel, the Scan indicator stops flashing. At
this time, both the Scan indicator and the Busy indicator light.
When the signal is no longer present, Scan resumes and the Scan indicator
flashes again.
To stop scanning, press the
Scan On/ Off
key again.
• The transceiver returns to the channel that was selected before Scan started.
If Group has been programmed onto a key, both groups will be scanned.
T
EMPORARY
D
ELETE
Depending on how your transceiver has been set up, a key may have been
programmed with the
Temporary Delete
function. If so, press and hold that
programmed key for approximately 1 second to temporarily remove undesired
channels from the scanning sequence. This allows you to scan only those
channels which you desire. After switching the Scan function OFF, or switching
the transceiver OFF and then ON again, the Scan settings return to normal.
Note:
In order for Scan to function, there must be at least 2 channels added to the scanning
sequence. If there are less channels than this, Scan does not operate.
R
EVERT
C
HANNEL
During Scan, pressing the
PTT
switch to transmit will cause the transceiver to
select the revert channel. Your dealer programs the Revert channel for your
transceiver. Consult your dealer for details.
Summary of Contents for TK-7108
Page 15: ......
