Kenwood TK-3260EX, Service Manual

Page: 3 / 14

TK-3260EX
3
SYSTEM SET-UP
REALIGNMENT
1..Modes
User mode
Data programming mode
PC test mode PC tuning mode
PC mode
Mode Function
User mode For normal use.
PC mode
Used for communication between the trans-
ceiver and PC.
Data programming
mode Used to read and write frequency data and
other features to and from the transceiver.
PC test mode
Used to check the transceiver using the PC.
This feature is included in the FPU.
2..How.to.Enter.Each.Mode
Mode Operation
User mode Power ON
PC mode Received commands from PC
3..PC.Mode
3-1..Preface
The transceiver is programmed by using a personal com-
puter, a programming interface (KPG-36/36A, USB adapter
(KCT-53U)) and FPU (programming software).
The programming software can be used with a PC. Figure
1 shows the setup of a PC for programming.
3-2..Connection.Procedure
1. Connect the transceiver to the personal computer with the
interface cable and USB adapter (when the interface cable
is KPG-36A, the KCT-53U can be used).
Note:
• You must install the KCT-53U driver in the computer to use
the USB adapter (KCT-53U).
• When using the USB adapter (KCT-53U) for the first time,
plug the KCT-53U into a USB port on the computer with
the computer power ON.
2. When the POWER is switched on, user mode can be en-
tered immediately. When the PC sends a command, the
transceiver enters PC mode.
When data is read from the transceiver, the red LED lights.
When data is written to the transceiver, the green LED
lights.
Choose the type of transceiver
Transceiver programming
Delivery
Merchandise received
A personal computer, programming interface (KPG-36/36A),
and FPU (programming software) are required for programming.
(The frequency and signalling data are programmed for the
transceiver.)
Are you using the optional antenna?
YES
NO
KRA-23 or KRA-27
Optional antenna
TX/RX 440~470 1.2W
TK-3260EX: E
Frequency range (MHz) RF power Type