blender unit
Before dismantling the blender, half
fill the goblet with warm water. Fit
the lid and cap then place on the
power unit. Switch to MIX and whilst
running, open the tap and allow the
water to drain into a container to
clean the valve. This can be
repeated until the water runs clear. If
further cleaning is necessary
dismantle the unit first.
power unit
●
Wipe with a damp cloth, then dry.
blade unit
1 Remove and wash the sealing ring.
2 Don’t touch the sharp blades - brush
them clean using hot soapy water,
then rinse thoroughly under the tap.
Don’t immerse the blade assembly in
water.
3 Leave to dry upside down away from
children.
lid, cap, stirrer
Wash by hand, rinse with clean
water then dry.
cleaning the tap
Remove the tap assembly from the
goblet, then soak the tap in hot
soapy water with the valve open
.
Wash thoroughly then rinse and dry.
Wash and dry the goblet then refit
the tap ensuring that the seals are
correctly positioned on the goblet
.
dismantling the tap
1 Hold the tap by the lever. Push up
on the plug
whilst sliding the lever
in the direction indicated
.
2 Unscrew the cap
.
3 Remove the spring
.
4 Push up on the plug on the inside of
the tap
and at the same time pull
the plug from above
.
5 Wash all the components, then dry
thoroughly.
6 Reassemble the unit by reversing the
above procedure.
service and customer
care
●
If the cord is damaged it must, for
safety reasons, be replaced by
KENWOOD or an authorised
KENWOOD repairer.
If you need help with:
●
using your Smoothie Blender
●
servicing or repairs
●
Contact the shop where you bought
your Smoothie Blender.
4
