G
Your kettle will boil and switch off automatically. To re-
boil, wait a few seconds - the on/off switch needs
time to reset.
Note - To interrupt the boiling ensure that
the switch is in the off position before
removing from the powerbase.
G
If you experience problems with your kettle
switching on and off during use or switching
off before boiling, check that the flat
element is free from scale - see
“descaling”.
G
Your kettle is fitted with a filter to hold back limescale
particles.
G
If you find drops of water under your kettle, don’t
worry - it is just condensation.
boil-dry protection
G
If you switch on with too little water, your kettle will
cut out automatically. Switch off, remove from the
powerbase and let it cool down before re-filling. When
it has cooled down, the switch will reset itself.
care and cleaning
G
Before cleaning, unplug your kettle and let it cool
down.
the outside and powerbase
G
Wipe with a damp cloth, then dry. Do not use
abrasives - they will scratch the metal and plastic
surfaces.
the inside
G
Even though your kettle comes with a filter, you still
need to clean the inside (and the filter) regularly.
the filter
1 Open the lid.
2 Slide the filter out
.
3
either
rinse under the tap or use a soft brush.
or
when descaling your kettle, drop the filter in too.
Rinse thoroughly.
4 Slide the filter back in to refit
.
descaling
G
Regular descaling of the flat element will improve the
performance of your kettle. If the kettle is not
descaled regularly the build up of limescale may result
in the following:
G
problems may be experienced with the kettle
switching on and off during use or switching off
before boiling.
G
the kettle may take longer to boil.
G
the flat element may be damaged.
Please note: Failure to descale your kettle may invalidate
your guarantee.
G
When limescale starts to build up on the heating
element, buy a suitable descaler and descale your
kettle. After descaling, boil with fresh water several
times and discard. Clean any descaler off the kettle -
it can damage the parts.
G
Some regions of the country have chalky water. This
makes boiled water look cloudy and leaves a deposit
on the side of the kettle. This is normal but can be
removed with regular cleaning.
G
Alternatively, to reduce limescale build up, use filtered
water to fill your kettle.
service and customer care
G
If the cord is damaged it must, for safety reasons, be
replaced by KENWOOD or an authorised KENWOOD
repairer.
G
If you experience any problems with the operation of
your appliance, before requesting assistance refer to
the “troubleshooting guide” section in the manual or
visit www.kenwoodworld.com.
G
Please note that your product is covered by a
warranty, which complies with all legal provisions
concerning any existing warranty and consumer rights
in the country where the product was purchased.
G
If your Kenwood product malfunctions or you find any
defects, please send it or bring it to an authorised
KENWOOD Service Centre. To find up to date details
of your nearest authorised KENWOOD Service centre
visit www.kenwoodworld.com or the website specific
to your Country.
G
Designed and engineered by Kenwood in the UK.
G
Made in China.
IMPORTANT INFORMATION FOR CORRECT
DISPOSAL OF THE PRODUCT IN ACCORDANCE
WITH THE EUROPEAN DIRECTIVE ON WASTE
ELECTRICAL AND ELECTRONIC EQUIPMENT
(WEEE)
At the end of its working life, the product must not be
disposed of as urban waste.
It must be taken to a special local authority differentiated
waste collection centre or to a dealer providing this service.
6