5-3. C L E A N I N G
5-6. O R D E R I N G S P A R E P A R T S
The DC Power Supply is likely to become soiled
after extended use. It should be cleaned with a
silicone cloth or a clean dry cloth.
CAUTION
Do not use volatile solvents such as alcohol, paint
thinner, gasoline, benzine, etc.
5-4. F U S E R E P L A C E M E N T
If the fuse blows, DISCONNECT the AC Power
Cable and contact and authorized KENWOOD
service facility; either your KENWOOD dealer, or the
factory to repair the cause.
NOTE
The following instructions are for use by either
your KENWOOD dealer, an authorized KENWOOD
service facility, or the factory.
WARNING
1. Never connect the AC cable to the AC outlet
until fuse replacement has been made.
2. Never use a fuse of higher rating. Replace with
a new fuse of the same rating.
This DC Power Supply is equipped with a fuse listed
below. If the fuse blows, check for the cause before
replacing the defective fuse. (Replacement fuses are
available from your authorized KENWOOD dealer.)
Version
Voltage Setting
Part Number
U.S.A. and
Canada
120 VAC
F05-6021-05 (6A)
Europe and
General Market
120 VAC
F05-6021-05 (6A)
Europe and
General Market
230 VAC
F05-4024-05 (4A)
U.K.
240 VAC
F05-4024-05 (4A)
Oceania
240 VAC
F05-3022-05 (3A)
NOTE
Fuse Holder is located on rear panel for U.S.A.
version as Fig. 4-2. © .
Other version except for U.S.A. version, fuse
holder is located inside of the top cover.
5-5. S U P P L Y C O R D R E P L A C E M E N T
( O c e a n i a version only)
If the supply cord of this appliance is damaged, it
must only be replaced by a repair shop appointed by
the manufacturer, because special purpose tools are
required.
NOTE
The following instructions are for use by either
your KENWOOD dealer, an authorized KENWOOD
service facility, or the factory.
When ordering replacement or spare parts for the
equipment, be sure to specify the following:
Model and Serial Number.
Schematic Number of the part.
Printed Circuit Board Number on which the
part is located.
Part Number and Name, if known, and
Quantity desired.
Part Numbers for most replacement parts are
contained in the Service Manual (usually available as
an option from KENWOOD dealer).
KENWOOD CORPORATION
KENWOOD ELECTRONICS AUSTRALIA PTY. LTD.
(A.C.N. 001 499 074)
P.O. BOX 504, B Figtree Drive, Australia Centre, Homebush N.S.W. 2140, Australia
7
Summary of Contents for PS-33
Page 10: ...KENWOOD ...
