Kenwood PS-33, Instruction Manual

Page: 5 / 10

3. INSTALLATION AND
CONNECTION
3-2. C O N N E C T I O N
NOTE
The following instructions are for use by either
your KENWOOD dealer, an authorized KENWOOD
service facility, or the factory.
WARNING
Never connect AC power to the DC Power Supply
until installation is complete.
3-1. I N S T A L L A T I O N
CAUTIONS
1. Prior to installation, check that the correct fuse
is installed.
2. Choose a location that is relatively free from
vibration.
3. Do not place the unit in a place which is
exposed to direct sunlight, near a heater, etc.
4. Do not store or use the unit in a dusty location
or in a moist atmosphere. Select a well
ventilated location.
5. To maintain good ventilation:
Remove the packing materials.
Do not cover the unit.
Place the unit at least 10 cm (4") away from
the walls.
6. (With the Europe and the General Markets
version only)
Prior to installation, check that the AC Voltage
Selector on the side panel is set to the correct
line voltage.
A C V O L T A G E S E L E C T I O N
With the Europe and General Markets version)
CAUTION
Make sure that the AC cable is disconnected
before selecting an AC voltage.
When changing an AC operating voltage, select the
desired voltage with the selector switch located on
the side cover. In this case, the correct fuse must
be installed, referring to Section 5-4. FUSE
REPLACEMENT.
WARNING
Never connect AC power to the DC Power Supply
until installation is complete.
CAUTIONS
1. Before connecting or disconnecting the DC
Power Cable, be sure to turn off the POWER
switches of both the radio and the DC Power
Supply.
2. Observe polarity of the DC Power Cable. The
radio operates on 13.8 VDC, negative ground.
NOTES
1. The DC Power Supply will not operate if the
output terminals are shorted.
2. The DC Power Supply may not operate if the
POWER switch is turned on with the radio in
transmit mode because the protection circuit
may operate.
1. Connect the DC Power Cable from the radio to
the Output Terminals on the Rear Panel, as
shown in Fig. 3-1..
Red lead -> Plus (+) Terminal
Black lead -> Minus (—) Terminal
2. Connect the AC power Cable to the AC outlet.
NOTE
Illustration shows the U.S.A. version.
Fig. 3 - 1 .
5
Black
Fuse Holders
To the Radio
Red
Output Terminals
AC outlet